|
 |
MANUFACTURER'S NAME:
|
NATIONAL COATINGS CORPORATION
1201 CALLE SUERTE
CAMARILLO, CA 93012
www.nationalcoatings.com |
EMERGENCY TELEPHONE: |
800-423-9557 |
DATE OF LAST REVISION: |
2/6/2008 |
SECTION I - PRODUCT IDENTIFICATION
| PRODUCT NUMBER: |
A200, A201 |
| PRODUCT NAME: |
LiquiSeal™ |
| PRODUCT CLASS: |
Asphalt Emulsion |
SECTION II - INFORMATION ON INGREDIENTS
| ASPHALT |
CAS# 8052-42-4 |
| CLAY |
CAS# 1332-58-7 |
| WATER |
CAS# 7732-18-5 |
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
| APPEARANCE: |
Brownish black, thixotropic liquid, slight acrylic odor |
| BOILING POINT: |
212ºF |
EVAPORATION RATE: |
Same as water |
| VAPOR DENSITY: |
Same as water |
WEIGHT PER GALLON: |
8.6 lbs. |
| VAPOR PRESSURE: |
Same as water |
% VOLATILE BY VOLUME: |
.05 maximum |
| V.O.C.: |
Actual = 0 gm/L |
Regulatory = 0 gm/L |
|
SECTION IV - REACTIVITY DATA
| STABILITY: |
Stable |
| HAZARDOUS POLYMERIZATION: |
Will not occur |
| HAZARDOUS DECOMPOSITION PRODUCTS: |
Combustion in air may yield oxides of carbon |
| INCOMPATIBILITY: |
Strong acids or bases |
SECTION V - FIRE & EXPLOSION HAZARD DATA
| FLAMABILITY CLASSIFICATION: |
Not DOT Regulated
Flash Point - Non combustible
LEL - N/A
|
| EXTINGUISHING MEDIA: |
On dried product – water, foam, CO2, dry chemical |
| UNUSUAL FIRE & EXPLOSIONS HAZARD: |
None |
| SPECIAL FIREFIGHTING PROCEDURES: |
For fires involving this material, do not enter any enclosed or confined space without proper protective gear, including self-contained breathing apparatus to protect against the hazardous effects of the normal products of combustion or oxygen deficiency. |
SECTION VI - SAFE HANDLING & USE INFORMATION
| RESPIRATORY PROTECTION: |
Not required |
| VENTILATION: |
Local exhaust not required |
| PROTECTIVE GLOVES: |
Impervious |
| EYE PROTECTION: |
Chemical splash goggles (ANSI Z-87.1 or approved equivalent) |
SECTION VII - HEALTH HAZARD DATA
EFFECTS OF OVER EXPOSURE:
- INHALATION: Vapor or mist can cause irritation of the nose, throat and lungs.
- EYE EXPOSURE: Possibly slightly irritating to eyes with direct contact.
- SKIN EXPOSURE: Possible skin irritant with repeated or prolonged contact.
EMERGENCY & FIRST AID PROCEDURES
- INHALATION: Move subject to fresh air.
- EYE & SKIN CONTACT: Flush eyes with large amounts of water for at least 15 minutes. Wash affected skin areas with soap and water. See a physician if irritation persists.
- INGESTION: If swallowed give two glasses of water to drink. See a physician.
SECTION VIII - SPILL OR LEAK PROCEDURES
| STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: |
Keep spectators away. Floor may be slippery, use care to avoid falling. Scoop or shovel solid material into a suitable container for recovery or disposal. Keep spills out of municipal sewers and open bodies of water. Dried spills may be steam cleaned or use a commercial degreasing compound. |
| WASTE DISPOSAL METHODS: |
Disposal should be in accordance with Federal, state, and local regulations. |
SECTION IX - SPECIAL PRECAUTIONS
| PRECAUTIONS TO BE TAKEN IN HANDLING & STORAGE: |
Keep from freezing. Keep tightly covered. Material may develop bacterial odor on long-term storage if contaminated. |
| OTHER PRECAUTIONS: |
None |
|
| |
|
|
|
